Basic introduction: epoxy zinc-rich primer based on epoxy resin, zinc powder as the main raw material, thickeners, fillers, additives, solvents and other components of the special coating product, the paint dry naturally fast, strong adhesion, anti- corrosion and other characteristics. Composition: epoxy resin with zinc powder, additives as the base material, polyamines formed. Main features: excellent corrosion resistance, strong adhesion, high zinc content in the film, with cathodic protection, excellent water resistance. The product is excellent corrosion resistance, good mechanical properties, adhesion, having conductivity and cathodic protection. A film formation 75um or more, can be used as shop shop primers. Its thick conducted at 15-25um welding, does not affect the welding performance, this product can also be used as anti-rust primer using a variety of pipes, gas cabinets. Main purpose: for heavy-duty supporting primer coating, cathodic protection, suitable for tanks, containers, steel structures, steel Guanxi, offshore platforms, ships, port facilities and the undercoat and other harsh environmental corrosion. Construction of reference: 1, recommended film thickness: 60-80um. 2, the surface to be coated must be free of scale, rust, oil and the like. 3, dosage: 0.2-0.25 kg per square (excluding losses) 4, mixing paint used within 6h. 5, brushing, air spray, roller can be. 6, the coating process must be constantly stirring to prevent precipitation. 7. Coating interval: substrate temperature ℃ 5-10 15-20 25-30 shortest interval h 48 24 12 Maximum intervals not exceeding 7 days. 8, the substrate temperature to be above the dew point 3 ℃, when the substrate temperature is below 5 ℃, the film is not cured, it is not construction. 9, after Part A barrel is open, you must stir, then stirring requested by the ratio in Group B into the Part A, fully mixed, standing, aging after 30min, add appropriate amount of diluent to adjust construction viscosity . Note: 1, diluents and dilution ratio: inorganic zinc-rich rust primer thinner 352, Surface treatment: steel surface must be approved by grinder rust or sand-blasting, arrived in Sweden rust standard Sa2.5 level . 3, curing time: 23 ± 2 ℃ 20 minutes. Applicable Time: 23 ± 2 ℃ 8 hours. Coating interval: 23 ± 2 ℃ Minimum 5 hours, up to seven days. 4. Suggested painting number: 2 to 3, in the construction, using a portable electric mixer to Part A (paste), stir stirring should be used to the construction side. Road after supporting: factory produced all kinds of intermediate paint, paint. Transport, Storage: 1, the product should be stored in a cool ventilated place to prevent direct sunlight, Isolated fire source, far away from a heat source. 2. When transporting, should prevent rain, sunlight exposure, to avoid the collision, and shall comply with the relevant provisions of the transportation sector. Security: the construction site should have good ventilation, painters should wear glasses, gloves, masks, avoid skin contact and inhalation of mist. The scene strictly forbids fireworks.